Technical Specifications

SPL
104 dB

Amplifier Power
50 W Bass (Class D) + 50 W Treble (Class D)

Frequency Response
45 Hz - 23 kHz ("-6 dB")

Accuracy of Frequency Response
± 1.5 dB (58 Hz - 20 kHz)

Driver Dimensions
⌀ 130 mm Bass + ⌀ 19 mm Treble (view in inches)

Dimensions
H 299 x W 189 x D 178 mm, with Iso-Pod™ (view in inches)

Weight
5.5 kg / 12.1 lb

Connections
1 x XLR Analog Input
1 x RJ45 AES67 Input
2 x RJ45 Control
8430A
IP SAM™ Studio Monitor
Technical Specifications
The 8430A is the world’s first AoIP studio monitor, allowing reference-quality monitor performance to integrate directly into your IP workflow.
The 8430A was in production between 2016 and 2023.

System Specifications
Frequency Response
58 Hz - 20 kHz (± 1.5 dB)
Low cutoff -6dB
45 Hz
High cutoff -6dB
23 kHz

SPL
Peak SPL Maximum peak acoustic output per pair, 1 m distance with music material.
≥110 dB
Short term max SPL Maximum short term sine wave acoustic output on axis in half space, averaged from 100 Hz to 3 kHz.
≥104 dB
Long term max SPL Maximum long term RMS acoustic output in same conditions with IEC weighted noise (limited by driver unit protection circuit).
≥96 dB
Self-generated noise
Self-generated noise Self generated noise level in free field on axis (A-weighted).
≤5 dB SPL
Weight
Weight5.5 kg (12.1 lb)
Dimensions
Height
285 mm
Height with Iso-Pod
299 mm
Width
189 mm
Depth
178 mm

Enclosure
Enclosure material
Die cast aluminium
Enclosure type
Reflex port
Drivers
Driver type
Cone
Diameter
130 mm
Driver type
Metal dome
Diameter
19 mm
Directivity


Harmonic distortion
> 100 Hz ≤0.5 %
Group delay
The latency at high frequencies from the input to the acoustic output, measured in the analog input:
Extended Phase Linearity in GLM set to OFF
2.3 ms
In Genelec performance graphics, the time of converting the from an electronic input signal to the acoustic output in a Genelec monitor is described by two factors – latency and group delay. The group delay factor can be read in the graphics for a specific frequency. The total frequency-specific input-to-output delay is a sum of the latency and group delay factors. To understand the significance of this total delay, consider that moving a loudspeaker away by 1 meter creates an additional delay of about 3 ms.
Amplifier Section
Amplifiers
50 W Class D
Bass amplifier short term output power.
50 W Class D
Treble amplifier short term output power.
Mains voltage
100-240 VAC 50/60Hz
Power consumption
ISS Active
≤0.5 W
Idle
≤3 W
Full output
50 W
Signal processing section
Connectors
Input Analog signal input connector XLR female, balanced 10 kOhm.
Input Audio-over-IP format and input connector:
2 x Control Two CAT5 (RJ45) GLM Network connectors for computer control using the Genelec Loudspeaker Manager (GLM) software.