Technical Specifications
SPL
100 dB
Amplifier Power
50 W Bass (Class D) + 50 W Treble (Class D)
Frequency Response
55 Hz - 23 kHz ("-6 dB")
Accuracy of Frequency Response
± 1.5 dB (66 Hz - 20 kHz)
Driver Dimensions
⌀ 105 mm Bass + ⌀ 19 mm Treble (view in inches)
Dimensions
H 242 x W 151 x D 142 mm, with Iso-Pod™ (view in inches)
Weight
3.2 kg / 7.1 lb
Connections
1 x XLR Analog Input
2 x RJ45 Control
8320A
SAM™ Studio Monitor
Technical Specifications
Compact enough to fit into the tightest of spaces - yet intelligent enough to adapt to your recording environment - the 8320A is your entry point into the world of Smart Active Monitoring.
System Specifications
Frequency Response
66 Hz - 20 kHz (± 1.5 dB)
Low cutoff -6dB
55 Hz
High cutoff -6dB
23 kHz
SPL
Peak SPL Maximum peak acoustic output per pair, at 1 m distance with music material.
≥107 dB
Short term max SPL Maximum short term sine wave acoustic output on axis in half space, averaged from 100 Hz to 3 kHz.
≥100 dB
Long term max SPL Maximum long term RMS acoustic output in same conditions with IEC weighted noise (limited by driver unit protection circuit).
≥94 dB
Self-generated noise
Self-generated noise Self generated noise level in free field on axis (A-weighted).
≤5 dB SPL
Weight
Weight3.2 kg (7.1 lb)
Dimensions
Height
230 mm
Height with Iso-Pod
242 mm
Width
151 mm
Depth
142 mm
Enclosure
Enclosure material
Die cast aluminium
Enclosure type
Reflex port
Drivers
Driver type
Cone
Diameter
105 mm
Driver type
Metal dome
Diameter
19 mm
Directivity
Harmonic distortion
> 200 Hz ≤0.5 %
Group delay
The latency at high frequencies from the input to the acoustic output, measured in the analog input:
Extended Phase Linearity in GLM set to OFF
2.8 ms
In Genelec performance graphics, the time of converting the from an electronic input signal to the acoustic output in a Genelec monitor is described by two factors – latency and group delay. The group delay factor can be read in the graphics for a specific frequency. The total frequency-specific input-to-output delay is a sum of the latency and group delay factors. To understand the significance of this total delay, consider that moving a loudspeaker away by 1 meter creates an additional delay of about 3 ms.
Amplifier Section
Amplifiers
50 W Class D
50 W Class D
Mains voltage
100-240 VAC 50/60Hz
Power consumption
ISS Active
≤0.5 W
Idle
≤3 W
Full output
50 W
Signal processing section
Connectors
Input Analog signal input connector XLR female, balanced 10 kOhm.
2 x Control Two CAT5 (RJ45) GLM Network connectors for computer control using the Genelec Loudspeaker Manager (GLM) software.